Mekanism · End game
Mekanism D-T Fuel Fusion Reactor Power Plant
This endgame Mekanism setup generates immense amounts of Forge Energy by synthesizing Deuterium and Tritium on-demand to feed a direct D-T Fuel Fusion Reactor. By utilizing maxed-out Thermal Evaporation Plants and a large array of Solar Neutron Activators, the power plant sustains continuous high-rate fuel burning without starving. Building this infrastructure solves all power needs permanently, enabling full-speed operation of the Supercritical Phase Shifter for Antimatter production.
- Footprint
- 32x24x18 blocks
- Power
- ~10 to 200+ MFE/t net output (check JEI/config for exact scaling)
- Throughput
- Up to 1000 mB/t of D-T Fuel
- Difficulty
- advanced
Flow diagram
How items, fluids and energy move through the setup, left to right.
Swipe sideways to see the whole diagram
Materials
| Item | Count |
|---|---|
| Fusion Reactor Controller | 1 |
| Fusion Reactor Frame | 60 |
| Fusion Reactor Port | 4 |
| Laser Focus Matrix | 1 |
| Thermal Evaporation Controller | 3 |
| Thermal Evaporation Valve | 9 |
| Thermal Evaporation Block | 378 |
| Resistive Heater | 3 |
| Solar Neutron Activator | 16 |
| Electric Pump | 32 |
| Filter Upgrade | 28 |
| Electrolytic Separator | 8 |
| Rotary Condensentrator | 2 |
| Chemical Infuser | 2 |
| Ultimate Pressurized Tube | 128 |
| Ultimate Mechanical Pipe | 128 |
| Ultimate Universal Cable | 128 |
| Ultimate Thermodynamic Conductor | 32 |
| Ultimate Chemical Tank | 6 |
| Laser | 9 |
| Laser Amplifier | 1 |
| Hohlraum | 1 |
| Speed Upgrade | 128 |
| Energy Upgrade | 128 |
| Muffling Upgrade | 36 |
Build it step by step
1Construct the Thermal Evaporation Plants
Build three 4x4 base, 18-block tall Thermal Evaporation Plants using Thermal Evaporation Blocks, three Valves, and one Controller per tower. Two of these towers will convert Water into Brine, while the third will convert that Brine into Liquid Lithium. Place a Resistive Heater against a valve on each tower (or connect via Ultimate Thermodynamic Conductors) and set their power draw high enough to maintain maximum tower temperature.
2Set Up the Lithium and Tritium Line
Place four Electric Pumps over infinite water sources with max Speed and Energy Upgrades to feed the two Brine towers via Ultimate Mechanical Pipes. Route the Brine output into the third tower to produce Liquid Lithium, then pipe that into two Rotary Condensentrators set to Decondensentrating mode to create Lithium gas. Route the Lithium gas through Ultimate Pressurized Tubes into an array of 16 Solar Neutron Activators (which must have direct sky access) to produce Tritium, and buffer the output in an Ultimate Chemical Tank.
3Establish the Deuterium Harvesting Array
Place 28 Electric Pumps over water source blocks and install a Filter Upgrade along with max Speed and Energy Upgrades in every pump. With the Filter Upgrade installed, these pumps will extract Heavy Water instead of regular water. Pipe the Heavy Water into 8 fully upgraded Electrolytic Separators set to dump excess Oxygen, and route the resulting Deuterium gas into an Ultimate Chemical Tank buffer.
4Synthesize the D-T Fuel
Connect your buffered Deuterium and Tritium Ultimate Chemical Tanks to two fully upgraded Chemical Infusers. These machines will combine the two gases at a 1:1 ratio to create D-T Fuel. Pipe the resulting D-T Fuel into a dedicated Ultimate Chemical Tank right next to your reactor site, and briefly connect a Rotary Condensentrator to fill a single Hohlraum with D-T Fuel for ignition.
5Assemble the Fusion Reactor
Build the 5x5x5 hollow hollow sphere-like structure of the Fusion Reactor using Fusion Reactor Frames, placing the Fusion Reactor Controller in the top center face. Install one Laser Focus Matrix on one side face, and four Fusion Reactor Ports on the remaining faces. Use a Configurator to set one port to Output mode for energy, while leaving the other three on Input mode for Deuterium, Tritium, and D-T Fuel.
6Build the Laser Ignition System
Place a Laser Amplifier facing directly into the Reactor's Laser Focus Matrix from a few blocks away. Set the Laser Amplifier's Redstone mode to High so it holds its charge, and configure its minimum threshold to at least 400 MFE (check JEI or the guidebook for your modpack's exact ignition requirement). Arrange 9 Lasers pointing into the faces of the Laser Amplifier and power them with Ultimate Universal Cables until the Amplifier builds up the required energy.
7Ignite and Connect to Grid
Pipe Deuterium, Tritium, and D-T Fuel from your storage tanks into the three input ports on the Fusion Reactor, and place the filled Hohlraum inside the Fusion Reactor Controller slot. Connect the energy output port to a large Induction Matrix using Ultimate Universal Cables. Flip a Lever on the Laser Amplifier to fire the ignition beam; the reactor will instantly ignite, begin consuming fuel, and flood your Induction Matrix with millions of FE per tick.
How it works
A Mekanism Fusion Reactor can run slowly by injecting Deuterium and Tritium separately at a controlled rate (up to 98 mB/t), or it can run at maximum overdrive by injecting pre-mixed D-T Fuel directly alongside them. When D-T Fuel is pumped straight into the reactor, it automatically burns up to 1000 mB/t (500 mB/t of each component equivalent) without obeying the standard GUI injection limit. This setup pipes all three gases into the reactor simultaneously so that even if D-T Fuel production dips at night, the separate Deuterium and Tritium buffers keep the plasma reaction alive without extinguishing.
Because Solar Neutron Activators only operate during daytime in clear weather, the Tritium production line is intentionally oversized and buffered with Ultimate Chemical Tanks. By using Resistive Heaters on the 18-block tall Thermal Evaporation Plants instead of relying on Top-mounted Advanced Solar Generators, the Brine and Liquid Lithium production runs 24/7 at max heat multiplier. The excess Lithium gas builds up overnight and is rapidly converted into Tritium the moment the sun rises, ensuring your chemical buffers never run dry during a standard day-night cycle.
Upgrades and scaling
- Water-Cooled Steam Loop: Pump Water into an extra input port on the Fusion Reactor and extract Steam into a massive Industrial Turbine, which will multiply your total power output several times over.
- Perpetual Day Dimension: Build the Solar Neutron Activator array or the entire plant in a dimension with permanent daylight (like the Mining Dimension or a space station if present in your pack) to eliminate night-time Tritium throttling.
- Entangloporter Fuel Distribution: Replace long Pressurized Tube runs with Quantum Entangloporters so you can build the massive Thermal Evaporation Towers far away from your main base lag zone.
Common mistakes
- Forgetting the Filter Upgrade in the Heavy Water Electric Pumps, which floods the Electrolytic Separators with regular Water and produces useless Hydrogen instead of Deuterium.
- Piping D-T Fuel into the Fusion Reactor before having full buffers and max production, causing the reactor to immediately gulp down all fuel at 1000 mB/t and extinguish a second after ignition.
- Forgetting to put a D-T Fuel-filled Hohlraum inside the Fusion Reactor Controller before firing the Laser Amplifier, which wastes the 400+ MFE laser shot without starting the plasma reaction.
- Breaking a block on an ignited Fusion Reactor or letting the fuel buffers empty completely, forcing you to wait for the Laser Amplifier to recharge another 400 MFE for re-ignition.
- Placing blocks above the Solar Neutron Activators or building them in a biome where it rains constantly, halting Tritium synthesis.
FAQ
Why do we pipe Deuterium, Tritium, and D-T Fuel into the reactor all at once?
If you only pipe in D-T Fuel and your buffer briefly empties at night, the reactor immediately shuts down. By also piping in raw Deuterium and Tritium at a low baseline injection rate (like 2 mB/t), the reactor stays ignited even if D-T Fuel temporarily runs out.
Can the Mekanism Fusion Reactor explode if it overheats?
No, unlike the Fission Reactor, the Mekanism Fusion Reactor cannot melt down or explode. Its high heat is purely beneficial and is used to generate more power or boil water into steam.
Why use Resistive Heaters on the Thermal Evaporation Plants instead of Advanced Solar Generators?
Resistive Heaters allow you to place a full 4x4 top layer on the tower (reaching the full 18-block maximum height bonus) and keep the tower at maximum temperature through the night and during rainstorms.