Create · End game
Nuclear Reactor & Neodymium Magnet Turbine Setup
This end-game setup harnesses the immense thermal power of a Create: New Age Nuclear Reactor to drive an industrial-grade steam engine. By pairing maximum-level rotational stress with Netherite Magnet rings and Generator Coils, this design produces massive amounts of electricity to power your entire base cleanly and efficiently.
- Footprint
- 13x9x10 blocks
- Power
- Massive FE/t output (Check JEI for your pack's coil conversion ratios)
- Throughput
- Continuous operation on minimal Nuclear Fuel
- Difficulty
- advanced
Flow diagram
How items, fluids and energy move through the setup, left to right.
Swipe sideways to see the whole diagram
Materials
| Item | Count |
|---|---|
| Reactor Casing | 64 |
| Reactor Glass | 24 |
| Reactor Rod | 9 |
| Reactor Fuel Inserter | 3 |
| Reactor Heat Vent | 3 |
| Boiler Heater | 9 |
| Heat Pipe | 32 |
| Fluid Tank | 36 |
| Steam Engine | 9 |
| Shaft | 16 |
| Mechanical Pump | 4 |
| Fluid Pipe | 16 |
| Rotation Speed Controller | 1 |
| Large Cogwheel | 2 |
| Generator Coil | 4 |
| Netherite Magnet | 96 |
| Carbon Brushes | 1 |
| Electrical Connector | 4 |
| Copper Wire | 8 |
| Mechanical Arm | 1 |
| Brass Funnel | 1 |
| Barrel | 1 |
Build it step by step
1Construct the Reactor Chamber
Build a hollow rectangular frame using Reactor Casings and Reactor Glass. Inside the structure, place three horizontal or vertical lines of Reactor Rods, ensuring they are completely enclosed by the radiation-shielding blocks to prevent lethal environmental contamination.
2Install Fuel Insertion & Vents
Place a Reactor Fuel Inserter at one end of each Reactor Rod line and a Reactor Heat Vent at the opposite end. Set up a Barrel with a Brass Funnel nearby, and configure a Mechanical Arm to automatically take Nuclear Fuel from the funnel and deposit it into the three Fuel Inserters.
3Place the Boiler Heaters
Lay down a 3x3 grid of Boiler Heaters a few blocks away from the reactor structure. Connect the Reactor Heat Vents directly to the Boiler Heaters using Heat Pipes so that thermal energy flows seamlessly out of the core.
4Assemble the Steam Boiler
Directly on top of the 3x3 Boiler Heater grid, place a 3x3x4 multiblock of Fluid Tanks. Attach nine Steam Engines around the upper walls of the tank and place Shafts on them to combine their rotational output.
5Plumb the Water Cooling
Connect four Mechanical Pumps to an infinite water source and pipe the water directly into the Fluid Tank boiler. Ensure the pumps are spinning fast enough to satisfy the maximum water consumption rate of a high-level boiler.
6Gear Up the Rotational Output
Combine the shafts from all nine Steam Engines into a main drive line using gearboxes or belts. Feed this main line into a Rotation Speed Controller paired with a Large Cogwheel, and crank the output speed up to 256 RPM.
7Build the Magnet & Coil Array
Run the 256 RPM shaft output horizontally and thread four Generator Coils along it. Surround each Generator Coil with a hollow 5x5 ring of Netherite Magnets (leaving the 3x3 center empty for the 1x1 coil block and air gap) to maximize the generation efficiency.
8Extract the Electricity
Place Carbon Brushes directly onto the spinning shaft adjacent to the Generator Coils. Attach an Electrical Connector to the Carbon Brushes and use Heavy or Copper Wires to route the resulting Forge Energy into your base's main battery bank or power grid.
How it works
Create: New Age replaces standard blaze burner mechanics with a dedicated thermodynamics system. As the Reactor Rods consume Nuclear Fuel (processed via crushing and washing radioactive Thorium ore), they generate immense quantities of heat. If left uncooled, the components will overheat and cause a catastrophic meltdown that turns surrounding blocks into molten waste. The Reactor Heat Vents and Heat Pipes act as a thermal bridge, pulling that dangerous heat away from the nuclear core and dumping it safely into the Boiler Heaters.
The Boiler Heaters translate the mod's heat mechanics into standard Create boiler heat levels, far outclassing conventional Blaze Burners without needing a steady stream of blaze cakes. This superheats the water inside the Fluid Tank to drive the nine Steam Engines at peak stress capacity. That massive pool of Stress Units (SU) is then compressed into a single 256 RPM shaft using the Rotation Speed Controller to overcome the heavy stress drain of the electrical generators.
Finally, the kinetic energy is converted into electricity via electromagnetic induction. As the Generator Coils spin rapidly inside the stationary rings of Netherite Magnets, they generate high-voltage rotational flux. The Carbon Brushes maintain physical contact with the spinning assembly, safely drawing the electrical current out as standard Forge Energy (FE) ready to be transmitted across your wire network.
Upgrades and scaling
- Add a Heat Pump along your Heat Pipe line to forcefully push thermal energy into the Boiler Heaters faster, preventing heat bottlenecks in larger reactor designs.
- Expand the turbine shaft to accommodate up to eight Generator Coils if you upgrade to an 18-engine max-size steam boiler.
- Install a Redstone Link and Threshold Switch on your main energy storage battery to automatically toggle the Fuel Inserters off when your base is fully charged, conserving Nuclear Fuel.
Common mistakes
- Leaving gaps in the Reactor Casing or Reactor Glass; any unshielded line of sight to active Reactor Rods will inflict severe radiation poisoning on nearby players.
- Powering the water pumps from the main steam turbine shaft without a backup kickstarter; if the water stops flowing, the boiler stalls, the heaters stop drawing heat, and the reactor will melt down.
- Placing magnets directly touching the Generator Coil faces instead of building a proper surrounding ring; check the Create Ponder scene for Generator Coils to ensure the magnet placement geometry is valid.
- Using low-tier Copper Wires to extract power from four Netherite-boosted coils, which will bottleneck your FE/t transfer rate or burn out the wires.
FAQ
How do I obtain Nuclear Fuel for the reactor?
You must mine radioactive Thorium ore, crush it using Create Crushing Wheels, wash the crushed output, and process it through a Mechanical Crafter or Sequenced Assembly with Iron Sheet casing; check JEI for your specific modpack's exact processing chain.
Why are my Netherrack or Iron Magnets not producing as much power?
Magnet tiers directly dictate both the efficiency of the kinetic-to-FE conversion and the stress impact on the shaft. Netherite Magnets provide the highest flux multiplier in Create: New Age.
What happens if my reactor actually melts down?
Overheated reactor blocks will catch fire, melt into lava and corium-like hazardous blocks, and release lingering deadly radiation across the chunk. Always test your water and heat piping before inserting the first fuel rod.