Ad Astra · Explained · Intermediate
Ad Astra Oxygen System Explained: Loaders, Distributors, and Sealed Bases
Surviving in the vacuum of space or on hostile alien worlds like the Moon and Mars requires a reliable supply of breathable air. This guide covers the complete Ad Astra life-support loop, teaching you how to extract oxygen from water, charge your Space Suit, and construct a fully pressurized, self-sustaining habitat. Mastering these mechanics allows you to explore indefinitely and take off your helmet safely inside your off-world bases.
What you need
- Oxygen Loader
- Oxygen Distributor
- Water Pump
- Power generation (Coal Generator or Solar Panel) and Cables
- Fluid Pipes and a Wrench
- Oxygen Tanks and a full Space Suit (Space Helmet, Space Suit, Space Pants, Space Boots)
- Solid building blocks and an Airlock or couple of Iron Doors
- Infinite water source (2x2 water pool) or Water Buckets
Step by step
1Set Up the Oxygen Loader on Earth
Before launching into space, craft and place an Oxygen Loader in your Overworld base. Connect it to a power source, such as a Coal Generator or Solar Panel, using Ad Astra Cables. The machine requires continuous energy to split water molecules into breathable oxygen.
Tip: Check your in-game Astrodux guidebook or JEI for exact crafting recipes, as components like Steel Plates require a Compressor.
2Supply Water to the Loader
For temporary setups, you can manually place Water Buckets into the left input slot of the Oxygen Loader's interface. For automation, dig a 2x2 infinite water source, place an Ad Astra Water Pump directly above one of the water blocks, and power the pump. Run Fluid Pipes from the Water Pump to the Oxygen Loader to fill its internal water tank automatically.
Tip: Use the Ad Astra Wrench on Fluid Pipes to configure their connection modes if fluids are not flowing properly.
3Fill Oxygen Tanks and Your Space Suit
As the Oxygen Loader receives power and water, its internal oxygen tank (on the right side of the GUI) will fill up. Place an empty Oxygen Tank or your Space Suit chestplate into the output slot below the oxygen gauge to transfer the gas. Always fill a few spare Oxygen Tanks to keep in your inventory for emergencies during planetary exploration.
Tip: You can consume oxygen directly from tanks in your inventory or shift-right-click holding a full Oxygen Tank to quickly transfer its contents into the Space Suit you are currently wearing.
4Build an Airtight Off-World Structure
Once you land on a lifeless body like the Moon, construct an enclosed room using solid blocks such as Iron Plating or Moon Stone Bricks. Ensure all corners, floors, and ceilings are completely connected without gaps. Avoid using partial blocks like stairs, slabs, or vanilla doors for the outer shell, as the mod's room-detection algorithm treats them as open holes.
Tip: Glass blocks work great for windows, provided they are full blocks and not glass panes.
5Construct a Functional Airlock
If you simply open a door to enter your base, the vacuum of space will instantly depressurize the room. Build a small two-door hallway at your entrance using either Ad Astra's dedicated Airlock blocks or two standard Iron Doors separated by a small chamber. Always close the outer door completely before opening the inner door to preserve your base's atmosphere.
Tip: Using pressure plates with Iron Doors is risky because both doors might open simultaneously; stick to buttons or levers for manual control.
6Install and Power the Oxygen Distributor
Place the Oxygen Distributor inside your sealed room, ensuring the top vent face is completely unobstructed by blocks. Run Cables from your planetary power grid (Solar Panels work exceptionally well on the Moon) and connect a steady water line using a local underground infinite water pool and a Water Pump. Once powered and watered, the Distributor will automatically synthesize and pump oxygen into the room.
Tip: You can hide your Cables and Fluid Pipes underneath the floor and connect them to the bottom of the Oxygen Distributor to keep your room tidy.
7Verify Pressurization and Seal Integrity
Open the Oxygen Distributor's GUI to monitor its status and activate the oxygen visibility overlay if you want to see the air blocks filling the room. If the chamber is properly sealed, the machine will quickly stabilize, and its power/water consumption will drop to a steady maintenance rate. Once pressurized, you can safely remove your Space Suit and grow Overworld crops inside.
Tip: If the machine complains of a leak or runs at maximum drain without stabilizing, trace your walls for missing blocks or replace fancy decorative blocks with standard solid cubes.
How it works
Ad Astra simulates electrolysis for its life support: both the Oxygen Loader and the Oxygen Distributor take in standard Water and Forge Energy (or Fabric equivalent) and convert them directly into Oxygen gas. Because water evaporates instantly when placed in hot or vacuum environments, you must first build and pressurize a small utility room before you can place down the water source blocks needed to automate your off-world Water Pump.
The Oxygen Distributor utilizes a 3D flood-fill algorithm (often referred to as a voxel check) starting from the block directly above the machine. It scans outward into every adjacent empty air block to map the interior volume of your base. If the scan hits solid blocks on all sides within its maximum volume limit, it declares the room sealed and converts the vacuum into breathable air.
A single Oxygen Distributor has a strict limit on the total number of air blocks it can support (check the machine's GUI or the Astrodux guidebook for the exact block cap in your mod version). The larger your room, the more water and energy the Distributor consumes per tick to maintain pressure. If your grand hall exceeds the block limit of one machine, the flood-fill check fails, and the room will act as if it has a leak unless you divide it with walls or add additional Distributors.
Common mistakes
- Placing water outside in a vacuum: Water source blocks will immediately freeze or vaporize on airless or superheated planets. Bring a couple of pre-filled Oxygen Tanks and Water Buckets from Earth to manually jumpstart your Distributor, pressurize the room first, and only then place your infinite water source inside the breathable zone.
- Building with non-full blocks: Using slabs, stairs, trapdoors, fences, or glass panes on the exterior hull of your base will cause an air leak. Even if a block looks visually sealed, the flood-fill algorithm usually requires full 1x1x1 opaque or glass blocks to register a valid boundary.
- Exceeding the Distributor's volume limit: Players often hollow out massive underground caverns and expect one Oxygen Distributor to fill it. If the interior volume is too large, the machine will simply drain your power and water while leaving you suffocating. Build modular rooms separated by doors instead of one gigantic dome.
- Relying on Coal Generators in space: Standard combustion fuels and torches do not burn in zero-oxygen environments unless placed inside an already pressurized room. Always bring Solar Panels to power your initial life-support infrastructure on alien worlds.
FAQ
Why does my Oxygen Loader work, but my Space Suit isn't protecting me?
You must wear all four pieces of the Space Suit (Helmet, Suit, Pants, and Boots) simultaneously to be protected from vacuum damage and extreme temperatures. Furthermore, the oxygen itself is stored specifically inside the chestplate (Space Suit), which must be charged inside the Oxygen Loader or via an Oxygen Tank.
Can I pipe oxygen from an Oxygen Loader into an Oxygen Distributor?
While the Oxygen Distributor has its own internal electrolysis processor and normally accepts water and power directly, you can also pipe pre-made oxygen into it. However, feeding water and power directly into the Distributor is far more compact and energy-efficient for base building.
How do I stop torches and lanterns from breaking on the Moon?
Standard fire-based light sources extinguish immediately in a vacuum. Either use glowstone, sea lanterns, and shroomlights for exterior lighting, or wait until your room is fully sealed and pressurized by an Oxygen Distributor before placing standard torches inside.
Do my tamed pets and villagers need Space Suits?
No, mobs cannot wear Space Suits, meaning they will quickly suffocate outside. To keep animals, villagers, or plants alive on other planets, they must stay strictly inside a room pressurized by an active Oxygen Distributor.
By combining a powered Water Pump, an Oxygen Loader for your Space Suit, and an Oxygen Distributor inside a solid-block structure with an airlock, you can establish permanent, breathable habitats on any celestial body in Ad Astra.