Mekanism · Addon guide · Beginner
Mekanism Generators Guide: How to Build an Ethylene Gas-Burning Power Plant
This guide teaches you how to transition from early-game Wind Generators to a fully automated, self-sustaining Ethylene Gas-Burning Power Plant using the Mekanism Generators addon. Mastering this setup is essential because Ethylene provides a massive, reliable mid-game power boost capable of running heavy machinery like the Digital Miner and advanced ore processing factories.
What you need
- Mekanism and Mekanism Generators mods installed
- 1x Wind Generator (for initial kickstart power)
- 1x Electric Pump (plus an infinite water source)
- 1x Electrolytic Separator
- 1x Crusher
- 1x Pressurized Reaction Chamber (PRC)
- 1x Gas-Burning Generator
- 1x Basic Energy Cube (or higher tier)
- Basic Universal Cables, Basic Mechanical Pipes, Basic Pressurized Tubes, and Basic Logistical Transporters
- 1x Configurator (essential for setting pipe and machine sides)
- A steady supply of plant matter (Melon Slices, Pumpkins, Potatoes, or Wheat)
Step by step
1Establish Kickstart Power with a Wind Generator
Before your Ethylene plant can run itself, you need initial electricity to start the chemical machines. Craft a Wind Generator and place it outdoors with a completely unobstructed view of the sky. Connect a line of Basic Universal Cables from the base of the Wind Generator down to a Basic Energy Cube at your building site to buffer the initial power.
Tip: Wind Generators produce much more power when placed at higher Y-levels, so consider building a pillar up into the sky and running cables down.
2Set Up Water and Hydrogen Production
Create a 2x2 infinite water source and place an Electric Pump directly one block above the water. Place an Electrolytic Separator nearby and connect the Pump to the Separator using Basic Mechanical Pipes. Power both machines using Universal Cables from your Energy Cube; the Separator will immediately begin splitting Water into Hydrogen and Oxygen.
Tip: Open the Electrolytic Separator's GUI and set the right-side Oxygen tank to 'Dump Excess' so the machine never stops producing Hydrogen when the Oxygen tank fills up.
3Automate Bio-Fuel Production
Place a Crusher near your setup and connect it to your power grid with Universal Cables. Place a chest filled with organic plant matter next to the Crusher and connect them using a Basic Logistical Transporter. Use your Configurator by shift-right-clicking the connection point at the chest until it flares out into 'Pull' mode, feeding crops into the Crusher to create Bio-Fuel.
Tip: Automated Melon farms are the community favorite here because slicing whole Melons in a Compacting Drawer or Crafting Table yields massive amounts of items for the Crusher.
4Place the Pressurized Reaction Chamber (PRC)
The Pressurized Reaction Chamber is the heart of the operation, requiring three distinct inputs: a liquid (Water), a gas (Hydrogen), and a solid item (Bio-Fuel). Place the PRC adjacent to both your Electrolytic Separator and your Crusher, and hook it up to your Universal Cable power line. Leave space around the PRC so you can cleanly route pipes into different faces of the machine.
Tip: You can place the PRC directly touching the Crusher and Electrolytic Separator to avoid using extra pipes, provided you align their input and output sides correctly.
5Configure the PRC Input Sides
Open the PRC's GUI and click the 'Side Config' tab on the left, which displays a color-coded map of the machine's six faces. Note the tabs for Items, Fluids, and Gases, and assign specific faces to be Inputs (typically Blue or Red depending on the resource tab) to match where your pipes will connect. Also, open the Crusher and Electrolytic Separator GUIs, go to their Side Configs, and enable 'Auto-Eject' at the top right so they push their products out automatically.
Tip: Hold the Configurator and shift-right-click a machine face in the world to quickly verify or cycle its current input/output mode.
6Route Water, Hydrogen, and Bio-Fuel into the PRC
Branch a Basic Mechanical Pipe from your Electric Pump's water line into the designated Fluid Input face of the PRC. Connect a Basic Pressurized Tube from the Hydrogen output face of the Electrolytic Separator (usually the left side when facing the front) to the PRC's Gas Input face. Finally, run a Basic Logistical Transporter from the Crusher's output face into the PRC's Item Input face.
Tip: Watch the internal gauges inside the PRC's GUI to confirm that Water, Hydrogen, and Bio-Fuel are all filling their respective bars.
7Connect the Gas-Burning Generator
Once all three ingredients are inside the PRC, it will process them into solid Substrate and gaseous Ethylene. Place your Gas-Burning Generator next to the PRC. Configure the PRC's Gas tab in Side Config to output (and turn on Gas Auto-Eject), then connect a Basic Pressurized Tube from that output face directly into the Gas-Burning Generator.
Tip: The PRC also produces Substrate as a solid item byproduct; attach a chest to the PRC's Item Output face so the machine does not halt when the internal item slot fills with Substrate.
8Close the Self-Sustaining Power Loop
Identify the green glowing energy output face on the front of the Gas-Burning Generator. Connect a Basic Universal Cable from this green port back into the Input face of your Basic Energy Cube. Once Ethylene hits the generator, it will produce far more electricity than the Pump, Separator, Crusher, and PRC consume, creating a massive net-positive energy loop.
Tip: After the loop is running stably, you can disconnect the starter Wind Generator and repurpose it elsewhere.
How it works
The entire system revolves around upgrading low-tier energy sources into a dense chemical fuel. While you can burn Hydrogen directly in a Gas-Burning Generator, doing so yields almost zero net power because the Electrolytic Separator consumes roughly the same amount of electricity to split the water as the Hydrogen generates when burned.
By introducing the Pressurized Reaction Chamber (PRC), you combine that Hydrogen with Water and easily renewable Bio-Fuel to synthesize Ethylene. Liquid Ethylene has an exceptionally high fuel density and burn duration in Mekanism Generators. A single PRC running at standard speed produces enough Ethylene to feed multiple Gas-Burning Generators simultaneously, turning a simple crop farm into an industrial powerhouse.
Mekanism's sided configuration logic is what makes this compact automation possible. Because every machine tracks Items, Fluids, Gases, and Energy on completely separate configuration tabs, a single machine like the PRC can accept three different states of matter at once without pipes clogging, provided each pipe type is routed to its corresponding configured face.
Common mistakes
- Forgetting to dump Oxygen in the Electrolytic Separator: If both internal gas tanks fill up, the machine stops working. Always set Oxygen to 'Dump Excess' unless you are actively piping it elsewhere.
- Letting Substrate clog the PRC: The PRC produces both Ethylene (gas) and Substrate (item). If the internal item output slot fills to 64 Substrate, the PRC stops making Ethylene. Always route Substrate out into a chest or trash can.
- Using the wrong pipe type: Mekanism separates transport strictly—Mechanical Pipes for liquids (Water), Pressurized Tubes for gases (Hydrogen/Ethylene), Logistical Transporters for items (Bio-Fuel), and Universal Cables for power. Mixing them up will prevent connections.
- Not turning on Auto-Eject: Setting a machine face to 'Output' in the Side Config is not enough; you must also toggle the 'Eject: On' button inside that same config tab, or set the attached pipe to 'Pull' with a Configurator.
FAQ
Why is my Hydrogen not entering the Pressurized Reaction Chamber?
Check two things: first, ensure you are using a Pressurized Tube (not a Mechanical Pipe). Second, open the PRC's Side Config, click the 'Gas' tab specifically, and make sure the side touching the tube is set to Input.
How many Gas-Burning Generators can one PRC support?
At base speed with a constant supply of crops, one PRC produces enough Ethylene to run multiple Gas-Burning Generators continuously. Check JEI and the generator's GUI for the exact burn rate in your specific modpack version, as pack authors frequently tweak Ethylene output.
What should I do with all the leftover Substrate?
Save at least a few chests of it! Later in Mekanism progression, you will combine Substrate with liquid Ethylene and Oxygen in another PRC to craft HDPE Pellets, which are required for high-tier Mekanism machines and the Mekasuit.
My setup stopped working after I logged out and back in. How do I fix it?
If your crop farm ran dry, the generators may have drained the Energy Cube completely, leaving no power to run the machines when crops return. Keep a charged Energy Cube or a connected Wind Generator on standby to jumpstart the machines if a blackout occurs.
By chaining an Electric Pump, Electrolytic Separator, Crusher, and Pressurized Reaction Chamber into a Gas-Burning Generator, you convert simple farm crops and water into an automated, high-output Ethylene power plant.