PneumaticCraft: Repressurized · Early game
Automated Explosion Crafting Compressed Iron Foundry
Before you can build a Pressure Chamber in PneumaticCraft: Repressurized, you must acquire Compressed Iron via world-space explosion crafting. This early-game Automated Explosion Crafting Foundry uses vanilla dispensers, water dampening, and smart redstone timing to safely convert whole stacks of raw iron into Compressed Iron without risking your base or losing items to secondary blasts.
- Footprint
- 5x5x6 blocks
- Power
- 0 FE/t (Pure Redstone & TNT)
- Throughput
- ~48 Compressed Iron Ingots per cycle (assuming ~20% loss rate; check JEI)
- Difficulty
- beginner
Flow diagram
How items, fluids and energy move through the setup, left to right.
Swipe sideways to see the whole diagram
Materials
| Item | Count |
|---|---|
| Obsidian | 26 |
| Dispenser | 1 |
| Dropper | 1 |
| Hopper | 3 |
| Chest | 2 |
| Barrel | 1 |
| Water Bucket | 1 |
| Observer | 2 |
| Sticky Piston | 1 |
| Redstone Repeater | 6 |
| Redstone Comparator | 1 |
| Redstone Torch | 2 |
| Redstone Dust | 14 |
| Stone Button | 1 |
| TNT | 16 |
| Iron Ingot or Block of Iron | 64 |
Build it step by step
1Construct the Blast Basin
Start by placing your output Barrel on the ground with a Collection Hopper feeding into the back of it. Build a 3x3x3 hollow cube of Obsidian directly above the Collection Hopper, leaving the bottom-center block open so items inside the chamber fall directly into the hopper. Obsidian acts as a failsafe in case the water source is ever accidentally removed.
2Waterlog the Chamber
Place a single Water Source directly on top of the Collection Hopper inside the 1x1x1 hollow center of your Obsidian cube. To prevent the water from flowing out if you leave an inspection window, use a waterlogged stair or surround the shaft solidly. The water nullifies all block damage from the TNT while still permitting entity damage and PneumaticCraft explosion crafting.
3Install Dropper and Dispenser
At the top of the 1x1 internal shaft, place the Iron Dropper and the TNT Dispenser facing inward or downward so their outputs drop straight into the water column. Place your Iron Input Chest feeding into the Iron Dropper via a hopper, and your TNT Supply Chest feeding into the TNT Dispenser via another hopper.
4Wire the Hopper Lock Mechanism
Run a redstone line holding a Redstone Torch adjacent to the bottom Collection Hopper so that the hopper is locked by default while the system is active. If the hopper were unlocked during dispensing, it would immediately suck up the raw Iron Ingots before the TNT could detonate. The lock will only release after the explosion finishes.
5Build the Fast Dropper Clock
Attach a Redstone Comparator reading from the Iron Dropper into a Sticky Piston pushing an Observer against a second Observer. Whenever iron is loaded into the dropper, the comparator activates the Observer clock, rapidly ejecting all Iron Ingots or Blocks of Iron into a tight cluster at the bottom of the water pit.
6Connect the TNT Delay Line
Take a signal off the Comparator using a falling-edge monostable circuit (or wire a manual Stone Button for batch control) that triggers once the Iron Dropper finishes emptying. Run this pulse into the TNT Dispenser to drop a single primed TNT directly onto the clustered iron waiting in the water below.
7Time the Post-Blast Collection
Branch the TNT trigger pulse into a line of 5 Redstone Repeaters set to maximum delay (4 ticks each, plus a small pulse extender) leading to the Redstone Torch locking the bottom Collection Hopper. Since primed TNT takes 4 seconds (80 game ticks) to explode, this delay ensures the hopper unlocks right after the blast converts the iron, safely sweeping your new Compressed Iron into the output Barrel.
How it works
In PneumaticCraft: Repressurized, dropping Iron Ingots or Blocks of Iron near an explosion converts them into Compressed Iron Ingots or Blocks of Compressed Iron, with a default configured loss rate of roughly 20% (check JEI for your modpack's exact loss percentage). When multiple items are caught in an explosion, Minecraft destroys dropped item entities instantly unless they undergo conversion on that exact tick. However, if a second explosion happens while converted Compressed Iron is still lying on the ground, those newly created items will be permanently vaporized.
This foundry solves the dual problems of block destruction and item loss through entity clustering and hopper locking. By locking the bottom Collection Hopper while the rapid Observer clock dumps up to a full stack of iron into the waterlogged chamber, all iron entities coalesce into a single spot. Because the chamber is flooded with water, the primed TNT deals zero structural damage to the surrounding redstone or hoppers, but still triggers the PneumaticCraft explosion crafting event across the entire stack of iron at once.
Only one TNT is dispensed per batch after the dropper empties. Once the 80-tick fuse expires and the blast transforms the stack, the delayed repeater line temporarily turns off the Redstone Torch locking the Collection Hopper. The hopper then pulls the newly formed Compressed Iron into the output Barrel before another cycle can begin, guaranteeing that converted items are never exposed to subsequent blasts.
Upgrades and scaling
- Craft Blocks of Iron before loading the Input Chest; Blocks of Iron convert 1:1 into Blocks of Compressed Iron with the same percentage loss calculation, effectively multiplying your throughput by 9x per single TNT.
- Transition to a full 3x3x3 Pressure Chamber as soon as you harvest roughly 36 to 64 Compressed Iron Ingots; the Pressure Chamber performs the exact same Iron-to-Compressed-Iron recipe using air pressure with a 0% loss rate.
- Replace the vanilla Collection Hopper beneath the water column with an Omnidirectional Hopper once you have spare Compressed Iron, and add Speed Upgrades to pull large multi-stack batches instantaneously.
Common mistakes
- Firing multiple TNT in rapid succession: A second TNT explosion will permanently delete the Compressed Iron items dropped by the first explosion before the hopper can collect them.
- Forgetting to lock the Collection Hopper during dispensing: An unlocked vanilla hopper will slowly pull raw Iron Ingots out of the blast zone while the TNT fuse is still burning, wasting your TNT.
- Building the blast chamber without water: Even if surrounded by Obsidian, an un-waterlogged explosion can destroy nearby exposed repeaters, chests, or the dropper face if the blast ray tracing finds a corner gap.
- Using this setup late into the game: Explosion crafting always suffers from an inherent item loss penalty (usually around 20%), so continuing to use TNT after you have enough materials to build a Pressure Chamber wastes a massive amount of iron.
FAQ
Is it better to use Iron Ingots or Blocks of Iron in the blast chamber?
Both work and suffer the same average percentage loss rate (check JEI for exact figures), but using Blocks of Iron is much more TNT-efficient because a single TNT can convert a whole stack of blocks at once, yielding nine times the Compressed Iron per explosion.
Why did all my Compressed Iron disappear after the explosion?
Either you dispensed two TNTs at the same time and the second blast destroyed the converted items from the first blast, or you threw a very small batch (like 1 or 2 ingots) and got unlucky with the random 20% item loss roll.
Can I use Creepers or other modded explosives instead of TNT?
Yes, any explosion capable of damaging entities will trigger the conversion, including PneumaticCraft Micromissiles or Creeper blasts, though vanilla TNT in a dispenser is by far the easiest and most predictable to time with redstone.